| Specification: | Instruction
1.Turn on
In the state of power off, press power key, yellow light comes on for about 5 second .When light tures into blue, pen recorder starts working
Notes: Mode transfer key was switched on “ video mode” before turn on, pen recorder goes into video mode and records.Switched mode transfer key on “ photograph mode” before trun on, pen recorder goes into “ photograph mode” directly and takes photograph
2.Start record
After turn on pen recorder, switch transfer key to “ video mode” , pen recorder goes into “ video mode” and starts recording
Notes: After turn on pen recorder , system needs time to ready each time.During this time, system is busy, please do not do other operations, such as press keys for several times, connect to computor.If capacity is larger, system needs longer time to ready
3.Stop record
In the state of video, press power key , pen recorder stops recording and stores video files.At this time, the light is yellow and pen recorder goes into state of standby.
4.Mode transfer operation
A: In the state of video or standby, switch mode transfer key to “ photograph mode” , pen recorder goes into “ photograph mode” .
B: When it is photograph mode , switch mode transfer key to “ video mode” .Pen recorder goes into “ video mode” and start recording
Notes: when transfer “ video mode” into “ photograph mode” , pen recorder stores video files automatically and then goes into “ photograph mode”
5.Take pictures
When it is “ photograph mode” , press power key , it takes a picture while yellow light twinkles a time showing
pictures were stored.Pen recorder is in “ photograph mode” at this moment
6.Go on record:
In the state of standby , press power key, yellow light turns into blue and pen recorder start recording
Notes:
a. In order to save electricity, if the device is in standby state and there is not any operation in one minute, the device will turn off automatically.
b. If the power is low while the device is recording, the device will store your video file first, and then turns itself off. You will need to charge the battery at this time.
c. Device stores video files automatically if video time is more than one and one half hours.
d. The system produces a new video file after a cycle of starting video and stopping video.
e. Storing files needs time. Please do not do any operation when the blue light turns into orange. Do not switch any buttons or connect to a computer. These operations will lead to failure to store files, storage of an incomplete file, file loss, or device failure.
f. Please keep pen body straight and stable under the bright light and stay farther than 50 cm from your subject.
7.Go on take pictures
When it is “ photograph mode” , press power key, pen recorder takes a picture and stores it and yellow light twinkles a time
Notes: Please keep enough time before take next picture as it needs time to store picture files.
8.Power off
In the state of “ video” , ” standby” or in “ photograph mode” , press power key for secondes and all lights turn off showing power off.
Notes:
In the state of video, press power key for seconds, system stores current video files automatically.Please make sure that press it until all lights turn off.
9.Connect with computer: In the state of power off or standby( yellow light) , pen recorder can be connected to a computer. At this time, the mark of removable disk shows up.The location of your video files is [ DRIVE} : MOVIERECORD” .When pull out removable disk, please click Safely Remove Hardware on your Windows taskbar at right bottom of computer screen and uninstall the removable storage device. When the system says you can remove hardware safely, please remove the cable to disconnect from the computer.
Notes: Due to different system and scheme of computer, it needs different time for computer to identify movable disks, please wait patiently. During this time, do not switch any keys to avoid affecting of identifying the movable disk. If the computer needs a long time to identify the movable disk, please try to plug in again. If the computer still cannot identify the hardware ( movable disk) , please check whether your system, drivers, USB port, and wiring is OK. Afer pull out pen recorder, please operate according to manual
10.Charge
In the state of power off or standby, plug USB cable and connect to USB port of computor.If battery is low, yellow light twinkles showing it is charging.At this time, please click remark of moveable disk at right bottom of computor screen, unintall moveable disk( please do not pull out USB cable) , press power key for secondes, blue light twinkles showing it is charging and it is in the state of power off
Notes: built-in high-capacity lithium battery, no memory effect. In order to activate max capability of battery and get standard working time, please use up battery at first 5 times and then charge until it is full.We recommend user to charge battery in the state of power off( blue light twinkles)
11.Reset
Please use toothpick shape nonmetal tiny stick, plug into reset hole, press reset key gently and then pen recorder is in the stand of power off.
Notes: When it can not work or stope working because of illegal operations and other unknow acts, we need to reset and keep strength properly to avoid of damaging parts.
12.Write
Swivel penholder, the pen ball is out.You can write and swivel penholer in reverse, pen ball pulls in. |
)